Kia Sorento: Under Body (4WD)
| Projected Dimensions |
| * These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ] |
| Actual-Measurement Dimensions |
| * These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Front side member tooling hole (Ø25) |
Front side member tooling hole (Ø25) |
Side cover mounting hole (Ø11) |
|
|
|
|
| Side cover mounting hole (Ø11) |
Front sub frame mounting bolt |
Front sub frame mounting hole (Ø18) |
|
|
|
|
| Floor under cover mounting hole (Ø6.6) |
Front sub frame mounting hole (Ø11) |
Front side member tooling hole (Ø14) |
|
|
|
|
| Floor under cover mounting hole (Ø7) |
Floor under cover mounting hole (Ø7) |
Rear trailing arm mounting hole (Ø19) |
|
|
|
|
| Rear sub frame mounting hole (Ø22) |
Rear sub frame mounting hole (Ø7) |
Rear sub frame mounting bolt |
|
|
||
| Rear floor side member tooling hole (Ø14) |
Under Body (2WD)
Front Cross Member
See also:
Adjusting instrument cluster illumination
To fine-tune the backlight brightness of your Kia Sorento instrument panel, press the illumination control buttons
(“+” or “-”) while the ignition switch or ENGINE START/S ...
IPM Trouble Diagnostics When Using GDS
1.
The IPM can be diagnosed by using the GDS. The BCM communicates
with the GDS which then displays inputs and outputs along with codes.
2.
...
Idle Stop and Go (ISG) system
The Idle Stop and Go system helps optimize urban fuel efficiency by automatically shutting down the engine of your
Kia Sorento whenever the vehicle comes to a complete halt during traffic congest ...