Kia Sorento: A/C Pressure Transducer Replacement - Air conditioning System - Heating,Ventilation And Air ConditioningKia Sorento: A/C Pressure Transducer Replacement

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / A/C Pressure Transducer Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).

4.
Remove the A/C pressure transducer (A).

Tightening torque :
10 ~ 12 N.m (1.0 ~ 1.2 kgf.m, 7.4 ~ 8.8 lb-ft)

  
Be careful not to bend the liquid & suction pipe.
5.
Install in the reverse order of removal.

  
When installing, replace it with a new O-ring (A).
A/C Pressure Transducer Inspection
1. Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”. 2. Inspect the voltage value w...
Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling...
See also:

Front Washer Motor Inspection
Front and Rear Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. &nb ...

Output Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification : Refer to "Signal Wave Form" section. ...

Installation
1. Install the mirror making sure the mounting bracket not to be damaged. 2. Install the mirror wiring cover after reconnecting the connect ...

Copyright © xm.ksmanual.com 2014-2026