Kia Sorento: Anti-Pinch Strip Removal
Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Power Tailgate Module / Anti-Pinch Strip Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
After loosening the mounting screws, then remove the tailgate
side trim (A).
(Refer to Body - "Tailgate")
|
| 3. |
Remove the anti-pinch strip sensor connector.
|
| 4. |
Remove the anti-pinch strip (A) after removing the clips (5EA).
|
Power Tailgate Inspection With GDS
1.
Check the power Tailgate module input/output value by using the
GDS. If the operation of power Tailgate module is abnormal, replace
...
Power Tailgate Latch Inspection
1.
Install the tailgate anti-pinch strip.
2.
Install the tailgate side trim.
3.
Connect the negative (-) battery terminal....
Anti-Pinch Strip Installation
See also:
Wheel Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Component Location
1. Fuel filler door open switch
2. Fuel filler door release actuator
...
Specifications
Direct control VFS[26/B]
▷ Control type : Normal low type
Control Pressure kpa
(kgf/cm², psi)
0 ~ 539.37 (0 ~ 5.5, 0 ~ 78.23)
Current value(mA)
...
Manuals list
- Kia Sorento MQ4 2021-2026 Owners Manual
- Kia Sorento XM 2011-2015 Owners Manual
- Kia Sorento XM 2011-2015 Service Manual
Copyright © xm.ksmanual.com 2014-2026 - 0.0656