Kia Sorento: Auto Head lamp leveling Unit Operation - Head lamp leveling Device - Body Electrical SystemKia Sorento: Auto Head lamp leveling Unit Operation

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Head lamp leveling Device / Auto Head lamp leveling Unit Operation

Operating Procedure
1.
Suspension angle change resulted from vehicle's load change.
2.
Height sensor signal change
3.
Calculation of HLLD signal by AHLS ECU algorithm.
4.
Sending a proper signal to HLLD (head lamp levelling device) and driving actuator.
5.
Actuation of HLLD and compensation of headlamp beam range.
Operating Condition
    Auto Head lamp leveling Unit Description
    According to driving environment and loading state of vehicle, head lamp lighting direction is changed to keep the driver's visibility range and to protect the driver's vision from glare...
    Auto Head lamp leveling Unit Removal
    Height Sensor & Unit 1. Disconnect the negative(-) battery terminal. 2. Remove the height sensor connector (A). ...
    See also:

    Components and Components Location. Roof Side Molding Repair Procedures
    Components and Components Location Component and Component Location Body Side Molding 1. Front Mud Guard2. Rear Mud ...

    Starter Removal and Installation
    Removal 1. Disconnect the battery negative ( - ) terminal. 2. Remove the air ...

    IMS Power Seat Control Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the power seat control switch connectors (A). (Refer to Body - "Front se ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0514