Kia Sorento: Auto Head lamp leveling Unit Removal - Head lamp leveling Device - Body Electrical SystemKia Sorento: Auto Head lamp leveling Unit Removal

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Head lamp leveling Device / Auto Head lamp leveling Unit Removal

Height Sensor & Unit
1.
Disconnect the negative(-) battery terminal.
2.
Remove the height sensor connector (A).

3.
Loosen the mounting bolts (2EA) from height sensor bracket after removing the linkage (A).

Torque :
3 ~ 5 N.m (0.3 ~ 0.5 kgf.m, 2.21 ~ 3.68 lbf-ft)

4.
Remove the height sensor.
Auto Head lamp leveling Unit Operation
Operating Procedure 1. Suspension angle change resulted from vehicle's load change. 2. Height sensor signal change 3. ...
Auto Head lamp leveling Unit Installation
Height Sensor & Unit 1. Install the height sensor. 2. Connect the connector....
See also:

EPB malfunction indicator. When the EPB is not released
EPB malfunction indicator If you press the ENGINE START/STOP button in the ON position, and the engine turns OFF after approximately 3 seconds while the system is operating normally, the followi ...

Antenna Removal
1. Remove the rear roof trim. (Refer to Body - "Roof trim") 2. Disconnect the power cable (A). 3. ...

Climate Control Air Filter Replacement
Replacement Front 1. Open the glove box (A). 2. ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0544