Kia Sorento: Balance Shaft & Oil Pump Installation
BSM(Balance Shaft Module) Chain System
|
1. |
The key of crankshaft should be aligned with the mating face of main
bearing cap. As a result of this, the piston of No.1 cylinder is placed
at the top dead center on compression stroke.
|
|
2. |
Insert a stopper pin (A) on the BSM to hold the sprocket at the reference
position with the timing mark (B) aligned with the timing notch (C).

|
New BSM has already been installed with a stopper pin at the
reference position.
|
|
|
3. |
Install the BSM (Balance Shaft Module).
|
(1) |
Tighten the bolts with seating torque 29.4 N.m (3.0kgf.m, 21.7
lb-ft) and then loosen the bolts.
|
|
(2) |
Using the SST (Torque Angle Adapter, 09221-4A000), tighten the
bolts with specified tightening torgue and angle.
Tightening torque
Bolts (A) (M9x181.5) : 22.6 ~ 26.5 N.m (2.3 ~ 2.7 kgf.m,
16.6 ~ 19.5 lb-ft) + 88 |
BSM (Balance Shaft Module) Chain System
1.
Remove the timing chain.
(Refer to Timing System in this group)
2.
Install a stopper pin (A)...
1.
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
2.
...
See also:Battery Sensor Description
Vehicles have many control units that use more electricity. These units
control their own system based on information from diverse sensors. It is important
to have a stable power supply as th ...
Audio Remote Control Removal
1.
Remove the driver airbag module.
(Refer to Restraint - "Airbag module")
2.
Remove the steering wheel front cover (A) after ...
Using the USB device
To use an external USB device, make sure the device is not connected when
starting up the vehicle. Connect the device after starting up.
If you start the engine when the USB device is connected ...
Copyright © xm.ksmanual.com 2014-2026 - 0.0478
| |