Kia Sorento: Oil Pressure Switch Inspection - Lubrication System - Engine Mechanical SystemKia Sorento: Oil Pressure Switch Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Inspection

1.
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.

2.
Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch.
3.
If there is no continuity when a 50kPa (0.50kgf/cm², 7.25psi) is applied through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm is broken. Replace it.

Balance Shaft & Oil Pump Installation
BSM(Balance Shaft Module) Chain System 1. The key of crankshaft should be aligned with the mating face of main bearing cap. As a result of this, the piston of No.1 cylinde...
Oil Level Gauge & Pipe Removal and Installation
1. Remove the oil gauge(A). 2. Remove the intake manofold. (Refer to Intake And Exhaust System - "Intake Manifold") ...
See also:

Components Location
1. Front axle 2. Front lower arm 3. Drive shaft 4. Sub frame 5. Stabilizer bar 6. Steering gearbox 7. Stabilizer link 8. Front strut assembly ...

Tightening Torque
Tightening torque Charging system Alternator Item N·m kgf·m ...

Cylinder Block Inspection
1. Remove gasket material. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Cl ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0547