Kia Sorento: BJ Boot Removal and Installation

Kia Sorento (XM, 2011-2015) Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Removal and Installation

1.	Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”)

2.	Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”)

3.	Remove the Dynamic damper. (Refer to Driveshaft Assembly - “Dynamic Damper”)

4.	Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.	Remove the BJ boot.

6.

Install in the reverse order of removal.

•	Do not disassemble the BJ assembly.

•	Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.

•	The boot band should be replaced with a new one.

BJ Boot Components

1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Retai...

Rear Axle Assembly

...

See also:

Seat warmer: (if equipped)
The integrated seat warmer system provides rapid and adjustable thermal comfort for vehicle occupants during chilly weather conditions in your Kia Sorento. ...

Panorama Sunroof Components
1. Roof side moulding [LH] 2. Roof side moulding [RH] 3. Movable glass 4. Slide 5. Cover base 6. Wind deflector 7. Panorama sunroof frame assembly 8. Mechanism rai ...

Emergency Fastening Device (EFD) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the negative (-) cable from battery and wait for at least thirty seconds. ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026