Kia Sorento: Brake Booster Removal - Brake System - Brake SystemKia Sorento: Brake Booster Removal

Kia Sorento (XM, 2011-2015) Service Manual / Brake System / Brake System / Brake Booster Removal

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly.
G 2.4 GDI (Refer to Engine Mechanical System - "Air Cleaner")
G 3.3 GDI (Refer to Engine Mechanical System - "Air Cleaner")
3.
Remove the master cylinder.
(Refer to Brake system - "Master cylinder")
4.
Disconnect the vacuum hose (A) from the brake booster.

5.
Remove the snap pin (A) and clevis pin (B).

6.
Remove the mounting nuts (A).

Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

7.
Remove the brake booster (A).

Brake Booster Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fu...
Brake Booster Inspection
1. Inspect the check valve in the vacuum hose, intensifier and the connecting section.    ...
See also:

Erasing programmed HomeLink buttons
To erase the three programmed buttons (individual buttons cannot be erased): Press and hold the left and center buttons simultaneously, until the indicator light begins to flash (approximately 20 ...

Rear Hub - Carrier Components
1. Rear carrier assembly 2. Parking brake assembly 3. Rear hub assembly 4. Rear brake disc ...

Fuel Line Removal and Installation
Removal Low Pressure Fuel Line [Low Pressure Delivery Pipe ↔ Fuel Tank] 1. Release the residu ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0701