Kia Sorento: Brake Pedal Removal - Brake System - Brake SystemKia Sorento: Brake Pedal Removal

Kia Sorento (XM, 2011-2015) Service Manual / Brake System / Brake System / Brake Pedal Removal

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel and reinforce panel.
(Refer to Body - "Crash pad lower panel")
3.
Remove the shower duct (A).

4.
Disconnect the stop lamp switch connector (A).

5.
Remove the brake pedal member mounting nut (A).

6.
Remove the snap pin (A) and clevis pin (B).

7.
Remove the brake pedal member assembly mounting nuts (A) and then remove the brake pedal assembly.

Brake Pedal Components
1. Cowl bracket 2. Brake pedal member assembly 3. Stop lamp switch 4. Brake pedal arm 5. Brake pedal pad...
Brake Pedal Inspection
1. Check the bushing for wear. 2. Check the brake pedal for bending or twisting. 3. Check the brake pedal return spring fo...
See also:

Rear Cross-Traffic Collision-Avoidance Assist settings. Rear Cross-Traffic Collision-Avoidance Assist operation
Rear Cross-Traffic Collision-Avoidance Assist settings Rear Cross-Traffic Safety ...

Battery Description and Operation
Description Battery Label Information 1. Battery Type - AGM : Absorbent Glass Material ...

Emergency Fastening Device (EFD) Description
Emergency Fastening Device (EFD) operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver and pass ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0722