Kia Sorento: Brake Pedal Inspection - Brake System - Brake SystemKia Sorento: Brake Pedal Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Brake System / Brake System / Brake Pedal Inspection

1.
Check the bushing for wear.
2.
Check the brake pedal for bending or twisting.
3.
Check the brake pedal return spring for damage.
4.
Check the stop lamp switch.
(1)
Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.
(2)
The stop lamp switch is in good condition if there is no continuity when plunger(A) is pushed.

Brake Pedal Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel and reinforce panel. (Refer to ...
Brake Pedal Installation
1. Pre-tighten the bracket fixing bolt (A) in dash panel. 2. Install the brake booster and brake pedal member fixing nuts (A) securely. ...
See also:

AVN Head Unit Components
AVN (A/V & Navigation) Head Unit Connector Connector Pin Information No. Connector A Connector B Connector C 1 - MM ...

System settings
Press the key Select [System] Select menu through TUNE knob Memory Information Displays currently used memory and total system memory. Select [Memory Information] OK The currently us ...

Shift Lever Removal and Installation
Removal 1. Shift the shift lever to the N range. ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0643