Kia Sorento: Compressor Disassembly - Air conditioning System - Heating,Ventilation And Air ConditioningKia Sorento: Compressor Disassembly

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Compressor Disassembly

1.
Remove the engine room under cover by loosening the mounting clip (A) and bolts (B).

2.
Separate the front portion of the front wheel guard from the wheel base.
(Refer to Body - "Body Side Moldings")
3.
Remove the engine room right side cover.

4.
Loosen the drive belt.
(Refer to Engine Mechanical System - "Drive Belt")
5.
Remove the center bolt (A) while holding the pulley with a disc & hub bolt remover (09977-25100).


Tightening torque :
15 ~ 21 N.m (1.5 ~ 2.1 kgf.m, 11.1 ~ 15.5 lb-ft)

6.
Loossen the hub bolts and then remove the hub assembly.

7.
Remove the pulley (B) after removing the snap ring (A) with a snap ring plier.

  
    1. Check the plated parts of the disc & hub assembly (A) for color changes, peeling or other damage. If there is damage, replace the clutch set. 2. ...
    1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers...
    See also:

    Description
    System Operation Typically, lane departure warning is activated at a speed over 60 km, but suppressed in case of unintentional lane departure when driver do not operate turn signal. S ...

    CVVT & Camshaft Installation
    1. Install the intakeCVVT assembly(A), exhaust CVVT assembly(B) and camshaft(C). Tightening torque : 53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39 ...

    TPMS Receiver On Vehicle Inspection. TPMS Receiver Repair procedures
    TPMS Receiver On Vehicle Inspection On Vehicle Inspection 1. Save the vehicle code, VIN, and sensor ID in the receiver and check wheth ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0478