Kia Sorento: Cylinder Block Reassembly - Cylinder Block - Engine Mechanical SystemKia Sorento: Cylinder Block Reassembly

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Cylinder Block / Cylinder Block Reassembly

1.
Install the oil jet (A).

Tightening torque :
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)

2.
Install the crankshaft.
(Refer to Cylinder Block - "Crankshaft")
3.
Install the piston & connecting rod assembly.
(Refer to Cylinder Block - "Piston And Connecting Rod")
4.
Install the ladder frame.
(Refer to Cylinder Block - "Ladder Frame")
Cylinder Block Inspection
1. Remove gasket material. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Clean cylinde...
Piston and Connecting Rod Components
1. Piston ring 2. Snap ring 3. Piston 4. Connecting rod 5. Connecting rod upper bearing 6. Connecting rod lower bearing 7. Connecting rod bearing cap...
See also:

Front Door Replacement
Front Door Trim Replacement    ...

Driver Airbag (DAB) On Vehicle Inspection. Driver Airbag (DAB) Troubleshooting
Driver Airbag (DAB) On Vehicle Inspection On Vehicle Inspection Diagnostic with KDS 1. The driver airba ...

IPM Components
Outer Connector (L / M / N / K) Connector Pin No. Description Active Remark K 1 IMS LIN     ...

Copyright © xm.ksmanual.com 2014-2026 - 0.054