Kia Sorento: Dynamic Damper Installation - Driveshaft Assembly - Driveshaft and axleKia Sorento: Dynamic Damper Installation

Kia Sorento (XM, 2011-2015) Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Installation

1.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
3.
Install the dynamic damper band (A).
4.
Using the SST(09495-3K000), secure the TJ boot bands (B).

Clearance (A): 2.0 mm (0.0787 in.) or less

5.
Install the TJ joint assembly.
(Refer to Driveshaft Assembly -
    Dynamic Damper Removal
    1. Remove the front driveshaft. (Refer to Driveshaft Assembly -...
    BJ Boot Components
    1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Retai...
    See also:

    Specifications
    Direct control VFS[35R/C] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 539.370 ~ 0 ( 5.5 ~ 0, 78.23 ~ 0) Current value(mA) ...

    Front Body B
    * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

    Rear Wiper Motor Removal
    1. Detach the rear wiper cap (A). 2. Remove the rear wiper arm & blade (A) after removing rear wiper HEX nut (B). ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0581