Kia Sorento: Dynamic Damper Removal - Driveshaft Assembly - Driveshaft and axleKia Sorento: Dynamic Damper Removal

Kia Sorento (XM, 2011-2015) Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Removal

1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly -
    Dynamic Damper Components
    1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Retai...
    Dynamic Damper Installation
    1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...
    See also:

    Removal
    1. Remove the head lamp. (Refer to "Lighting system") 2. Remove the bolts and disconnect the horn connectors, then remove ...

    Floor Console Assembly Repair Procedures
    Removal 1. Remove the console upper cover. (Refer to Floor Console - "Console Upper Cover") ...

    Drive Belt Inspection
    1. Visually check the belt for excessive wear, frayed cords etc. If any defect has been found, replace the drive belt.   ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0703