Kia Sorento: Engine Control Module (ECM) Removal - Engine Control System - Engine Control / Fuel SystemKia Sorento: Engine Control Module (ECM) Removal

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / Engine Control Module (ECM) Removal

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the ECM Connector (A).

3.
Remove the battery.
(Refer to Engine Electrical System - "Battery")
4.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
5.
Remove the mounting bolt (A) and nuts (B), and then remove the ECM (C).

6.
After romoving the installation nuts (A) and screws (B), romove the ECM (C) from the bracket.

Engine Control Module (ECM) Circuit Diagram
...
Engine Control Module (ECM) Installation
1. Install in the reverse order of removal. ECM installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m,7.2 ~ 8.7 lb-ft) ECM bracket in...
See also:

Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Steering Gear Rack, Linkage and Boots Repair procedures
Repair procedures Steering Wheel Play Inspection 1. Align the steering wheel straight. ...

Passenger Airbag (PAB) Removal and Installation
Removal 1. Disconnect the battery negative ( - ) terminal. ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0473