Kia Sorento: Engine Control Module (ECM) Installation - Engine Control System - Engine Control / Fuel SystemKia Sorento: Engine Control Module (ECM) Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / Engine Control Module (ECM) Installation

1.
Install in the reverse order of removal.

ECM installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m,7.2 ~ 8.7 lb-ft)
ECM bracket installation bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m,7.2 ~ 8.7 lb-ft)

  
Perform TCM learning after replacing the PCM.
(Refer to Automatic Transaxle Control System - "Adjustment")
Engine Control Module (ECM) Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the ECM Connector (A). 3. ...
ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is found, repair...
See also:

Component Location
1. Driver power window main switch 2. Passenger window switch 3. Front window motor 4. Rear window motor 5. Rear window switch ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose. (Re ...

OD Clutch & LR Brake Control Solenoid Valve (OD/C & LR/B_VFS) Removal
Removal ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0521