Kia Sorento: Engine Room Under Cover Removal and Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Room Under Cover Removal and Installation

1.

Unfasten the fasteners and bolts and then remove the engine room under cover (A).

Tightening torque:

7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

2.

Remove the engine room side cover(A).

Tightening torque:

7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

[RH]

[LH]

3.	Install in the reverse order of removal.

Engine Room Under Cover Components

1. Under Cover 2. Side Cover (RH) 3. Side Cover (LH)...

Engine Mounting Components

1. Transaxle mounting bracket 2. Roll rod bracket 3. Engine mounting bracket 4. Engine mounting support bracket...

See also:

Operation
Evaporative System Monitoring Evaporative And ORVR Emission Control System This system consists of below items; - Fill vent valve - F ...

Panorama Sunroof Adjustment
Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it. ...

Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset / relearned according to the following procedure. 1. Check DTC(s) and clear if exist. ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026 - 0.0368