Kia Optima Manuals

Kia Sorento: Front Impact Sensor (FIS) Installation - SRSCM - RestraintKia Sorento: Front Impact Sensor (FIS) Installation

Kia Sorento (XM, 2011-2015) Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Installation

  
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque
: 6.8 ~ 9.2 Nm (0.7 ~ 0.9 kgf.m, 5.0 ~ 6.8 lb.ft)
3.
Connect the front impact sensor connector.
4.
Reconnect the battery negative cable.
5.
After installing the front impact sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS) Removal
   • Removal of the airbag must be performed according to the precautions/ procedures described previously. ...
Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar nearby ...
See also:

Rear Disc Brake Replacement
1. Remove the rear wheel & tire. 2. Loosen the guide rod bolt (B) and pivot the caliper (A) up out of the way. ...

HomeLink® 5 programming flow chart
...

Front seat adjustment - manual
Forward and backward To move the seat forward or backward: 1. Pull the seat slide adjustment lever up and hold it. 2. Slide the seat to the position you desire. 3. Release the lever and make sur ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026