Kia Optima Manuals

Kia Sorento: Front Wheel Transfer Assembly Installation - Transfer Assembly - 4 Wheel Drive (4WD) SystemKia Sorento: Front Wheel Transfer Assembly Installation

Kia Sorento (XM, 2011-2015) Service Manual / 4 Wheel Drive (4WD) System / Transfer Assembly / Front Wheel Transfer Assembly Installation

1.
Install in the reverse order of removal.
  
1.
Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one.
2.
Smear and cover splines (B) with molybdenum type high pressure grease.
TECHLUBE MEGAMAX - ALPHA or equivalent

3.
Install the propeller shaft to be near runout marking (Transfer assembly 1ea, propeller shaft 1ea) each other.
Front Wheel Transfer Assembly Removal
   It is not recommended to overhaul the transfer assembly because a special three-dimensional measuring instrument is required to determine the s...
Oil Seal Replacement
[Right side] 1. Remove the front muffler. (Only gasoline 3.3) (Refer to Engine Mechanical System - "Front Muffler ") 2. Remov...
See also:

3. TCM Terminal input/ output signal
Connector [A] Pin No. Signal Condition Type Level 29 Sports mode up switch Up ON Input 0V/Battery voltage level ...

ICM Relay Box Inspection
Rear Wiper Motor relay Check for continuity between the terminals. 1. There should be continuity between the No.1 and No.3 terminals when power and ground are conne ...

Oil Cooler Installation
1. Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler with fix bolt (B). Tightening torque: ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026