Kia Sorento: Oil Seal Replacement

Kia Sorento (XM, 2011-2015) Service Manual / 4 Wheel Drive (4WD) System / Transfer Assembly / Oil Seal Replacement

[Right side]

1.	Remove the front muffler. (Only gasoline 3.3) (Refer to Engine Mechanical System - "Front Muffler ")

2.	Remove the driveshaft assembly. (RH side) (Refer to Driveshaft and axle - "Front Driveshaft ")

3.	Remove the dust cover (A).

4.	Remove the oil seal (A, B).

5.

Install the oil seal with special service tools.

•	Apply lithium type grease between seal lips.

•	Use the oil seal installer (09473-3B100) after removing the coupling (A).

6.	Install the new dust cover (A).

7.	Add to transfer fluid. (Refer to 4 Wheel Drive System - "Transfer Fluid")

8.	Install the drive shaft assembly. (RH side) (Refer to Driveshaft and axle - "Front Driveshaft ")

9.	Install the front muffler. (Only gasoline 3.3) (Refer to Engine Mechanical System - "Front Muffler ")

[Left side]

1.	Remove the transfer assembly from the transaxle assembly. (Refer to Transfer Assembyl - "Front Wheel Transfer Assembly")

2.	Remove the oil seal (A). [Gasoline 2.4] [Gasoline 3.3]

3.

Install the oil seal with special service tools.

•	Apply lithium type grease between seal lips.

•	Use the oil seal installer (09473-3B100) after removing the coupling (A). (Gasoline 2.4)

•	Use the oil seal installer (09473-3B100) after installing the coupling (A). (Gasoline 3.3)

[Gasoline 2.4]

[Gasoline 3.3]

4.	Add to transfer fluid. (Refer to 4 Wheel Drive System - "Transfer Fluid")

5.	Install the transfer assembly. (Refer to 4 Wheel Drive System - "Front Wheel Transfer Assembly")

Front Wheel Transfer Assembly Installation

1. Install in the reverse order of removal. 1. Be ca...

4WD Control System

...

See also:

Compressor Oil Specification
1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. ...

Front Wiper Motor Inspection
Speed Operation Check 1. Remove the connector (A) from the wiper motor. 2. Attach the positive (+) lead from the battery to terminal ...

Specification
[Throttle Position Sensor (TPS)] Throttle Angle(°) Output Voltage(V) TPS1 TPS2 0 0.0 5.0 10 0.48 4.52 ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026