Kia Sorento: Fuel Filler Door Open Switch Inspection
| 1. |
Remove the front door trim panel.
(Refer to Body - "Front door")
|
| 2. |
Disconnect the switch connector (A) from wiring.
|
| 3. |
Check the switch for continuity between the No. 1 and No. 2 terminals.
If the continuity is not as specified, replace the switch.
|
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification :
Refer to "Signal Wave Form" section.
...
Radiator Repair procedures
Removal and Installation
1.
Disconnect the battery negative ( - ) terminal.
2.
...
Inspection (With GDS)
1.
Check IPM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
...