Kia Sorento: Fuel Pump Inspection - Fuel Delivery System - Engine Control / Fuel SystemKia Sorento: Fuel Pump Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pump Inspection

[Fuel pump motor]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecting power (No.4) and ground (No.5).

Pin No.
Description
1
Fuel sender signal
2
-
3
Fuel sender ground
4
Fuel pump motor (+)
5
Fuel pump motor ground

[Fuel sender]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.

Pin No.
Description
1
Fuel sender signal
2
-
3
Fuel sender ground
4
Fuel pump motor (+)
5
Fuel pump motor ground

4.
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
Position
Resistance(Ω)
E
197 ~ 203
Warning lamp
168 ~ 172
 1/2
64.2 ~ 68.2
Sender (F)
6 ~ 10

Fuel Tank Installation
1. Install in the reverse order of removal. Fuel tank band installation bolt: 44.1 ~ 58.8 N.m (4.5 ~ 6.0 kgf.m, 32.6 ~ 43.4 lb-ft)...
Fuel Pump Removal
1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line") ...
See also:

On Vehicle Inspection. Rear PWM-FET Removal and Installation
On Vehicle Inspection On Vehicle Inspection Diagnostic with KDS 1. The rear A/C system can be more quic ...

Circuit Diagram
...

Front Wiper Motor Inspection
Speed Operation Check 1. Remove the connector (A) from the wiper motor. 2. Attach the positive (+) lead from the battery to terminal ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0523