Kia Sorento: In-car Sensor Replacement - Air conditioning System - Heating,Ventilation And Air ConditioningKia Sorento: In-car Sensor Replacement

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / In-car Sensor Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel (A).

3.
Disconnect the clock connector (A).

4.
Disconnect the heater and A/C controller connectors (A).

5.
Loosen the mounting 2 screws and then remove the in-car sensor (A).

6.
Install in the reverse order of removal.
In-car Sensor Inspection
1. Turn the ignition switch ON. 2. Blow air with changing temperature into the in-car sensor air inlet. Measure the sensor resistance between 1 and 2 ...
Photo Sensor Description
The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving por...
See also:

General Troubleshooting Information
Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Using the battery checker (MCR-570 KIT), check the ba ...

Brake Pedal Installation
1. Pre-tighten the bracket fixing bolt (A) in dash panel. 2. Install the brake booster and brake pedal member fixing nuts (A) secur ...

TJ Joint Components
[LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Retainer ring 10. ...

Copyright © xm.ksmanual.com 2014-2026