Kia Sorento: Installation - Ignition Switch Assembly - Body Electrical SystemKia Sorento: Installation

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Ignition Switch Assembly / Installation

1.
Install the key lock cylinder.
2.
Install the illumination bulb, lens and cover.
3.
Install the key warning and immobilizer connector.
4.
Install the ignition switch.
5.
Install the steering column shrouds and crash pad lower panel.
Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds. (Refer to Steering System - "Steering ...
Rear Parking Assist System
...
See also:

Surround View Monitor settings
Warning Methods ...

Replacement
The injector combustion seal should be replaced new one to prevent leakage after removing the injector. 1. Remove the combustion seal (A) with a wire cutter. ...

Front Body D
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Copyright © xm.ksmanual.com 2014-2026