Kia Sorento: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
DON’T use a cleaner, spray, or grease to sensing element
and connector of the sensor because oil component in them may
malfunction the sensor performance.
|
| •
|
Sensor and its wiring may be damaged in case of contacting
with the exhaust system (Exhaust Manifold, Catalytic Converter,
and so on).
|
|
|
1. |
Install in the reverse order of removal.
Heated oxygen sensor installation:
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the connector (A), and then remove the sensor (B).
...
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures
the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor co...
See also:
Fuel Tank Removal
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
...
Airbag Disposal
Special Tool Required
Deployment tool 0957A-34100A
Before scrapping any airbags or side airbags (including those in a whole
vehicle to be scrapped), the airbags or side airbags ...
Front Bumper Replacement
•
Pry the trim off using a plastic trim tool and apply protective
tape around the rela ...
Removal
Rail Pressure Sensor (RPS)
