Kia Sorento: Rail Pressure Sensor (RPS)
Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS)
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures
the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor converts the pressure to voltage signal. By using
this signal, the ECM can control correct injection amount and timing and adjusts
the fuel pressure with the fuel pressure regulator valve if the target pressure
and the actual pressure calculated by the RPS output signal are different.
...
Installation
...
Specification
See also:
SS-A Solenoid Valve(ON/OFF)
SS-A solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears.
SS-A Solenoid valve(ON/OFF) is installed at valve body.
...
Radiator Removal and Installation
1.
Disconnect the battery terminals.
2.
Remove the air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner" ...
Rear Body
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Side outer p ...
Manuals list
- Kia Sorento MQ4 2021-2026 Owners Manual
- Kia Sorento XM 2011-2015 Owners Manual
- Kia Sorento XM 2011-2015 Service Manual
Copyright © xm.ksmanual.com 2014-2026 - 0.0291