Kia Sorento: Manual transaxle (If equipped)

Manual transaxle operation
The manual transaxle has 6 forward gears.
This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized
in all forward gears so shifting to either a higher or a lower gear is easily accomplished.
Press the clutch pedal down fully while shifting, then release it slowly.
If your vehicle is equipped with an ignition lock switch, the engine will not
start when starting the engine without depressing the clutch pedal. (if equipped)
The gearshift lever must be returned to the neutral position before shifting
into R (Reverse).
The button (1) located immediately below the shift knob must be pulled upward
while moving the shift lever to the R (Reverse) position. (if
equipped)
Make sure the vehicle is completely stopped before shifting into R (Reverse).
Never operate the engine with the tachometer (rpm) in the red zone.
CAUTION
- When downshifting from fifth gear to fourth gear, caution should be taken
not to inadvertently press the gear shift lever sideways in such a manner that
second gear is engaged. Such a drastic downshift may cause the engine speed
to increase to the point that the tachometer will enter the red-zone. Such over-revving
of the engine may possibly cause engine damage.
- Do not downshift more than 2 gears or downshift the gear when the engine
is running at high speed (5,000 RPM or higher). Such a downshifting may damage
the engine, clutch and the transaxle.
- During cold weather, shifting may be difficult until the transaxle lubricant
has warmed up. This is normal and not harmful to the transaxle.
- If you've come to a complete stop and it's hard to shift into 1st or
R (Reverse), put the shift lever in N (Neutral) position and release the clutch.
Press the clutch pedal back down, and then shift into 1st or R (Reverse) gear
position.
CAUTION
- To avoid premature clutch wear and damage, do not drive with your foot
resting on the clutch pedal. Also, don
Illuminated Engine Start/Stop button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience.
The light will go off after about 30 seconds when the do...
Automatic transaxle operation
The automatic transaxle has 6 forward speeds and one reverse speed. The individual
speeds are selected automatically, depending on the position of the shift lever.
...