Kia Sorento: Starter Cleaning - Starting System - Engine Electrical SystemKia Sorento: Starter Cleaning

Kia Sorento (XM, 2011-2015) Service Manual / Engine Electrical System / Starting System / Starter Cleaning

1.
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will damage the insulation wipe these parts with a cloth only.
2.
Do not immerse the drive unit in cleaning solvent.
The overrun clutch is pre-lubricated at the factory and sol-vent will wash lubrication from the clutch.
3.
The drive unit may be cleaned with a brush moistened with cleaning solvent and wiped dry with a cloth.
Starter Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If the st...
Starter Relay Inspection
1. Disconnect the battery negative terminal. 2. Remove the fuse box cover. 3. Remove the starter relay(A). ...
See also:

Dynamic Damper Components
1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly ...

Description and Operation
Description • ISG system improves fuel efficiency and reduces emissions by temporary stop the vehicle engine eithe ...

Hitches. Safety chains
Hitches Selecting and installing the correct trailer hitch equipment is vital for maintaining stability against challenging road elements such as crosswinds, passing commercial trucks, and uneve ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0488