Kia Sorento: Master Cylinder Removal - Brake System - Brake SystemKia Sorento: Master Cylinder Removal

Kia Sorento (XM, 2011-2015) Service Manual / Brake System / Brake System / Master Cylinder Removal

1.
Turm ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly.
G 2.4 GDI (Refer to Engine Mechanical System - "Air clecner")
G 3.3 GDI (Refer to Engine Mechanical System - "Air clecner")
3.
Disconnect the brake fluid level switch connector (B), and remove the reservoir cap.

4.
Remove the brake fluid from the master cylinder reservoir with a syringe.
  
    1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder...
    1. Installation is the reverse of removal. 2. After installation, bleed the brake system. (Refer to Brake system - "Brake system Bleeding&quo...
    See also:

    Components
    1. HECU module 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. Yaw rate & Lateral G sensor 5. ABS Warning lamp 6. Parking brake/EBD warning lamp 7. ESC F ...

    Cluster Unit Removal and Installation
    Removal 1. Remove the cluster support bracket. (Refer to Body - "Cluster Support Bracket) ...

    On Vehicle Inspection
    On Vehicle Inspection Diagnostic with KDS 1. The seat electric can quickly diagnosed for problems with ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0559