Kia Sorento: Oil Pan Installation - Lubrication System - Engine Mechanical SystemKia Sorento: Oil Pan Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Lubrication System / Oil Pan Installation

1.
Install the oil pan.
(1)
Using a gasket scraper, remove all the old sealant material from the gasket surfaces.
(2)
Before assembling the oil pan, liquid sealant Loctite 5900H, Threebond 1217H or equivalent should be applied on oil pan. The part must be assembled within 5 minutes after sealant was applied.

Bead width : 3.0 mm (0.12 in.)

  
    1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the A/C compressor. (Refer to Heating, Ventilation, ...
    1. Balance shaft & oil pump assembly 2. Balance shaft chain tensioner 3. Balance shaft chain 4. Balance shaft chain sprocket 5. Balance shaft chain guide 6. Balance shaft chain ...
    See also:

    Rear View Monitor malfunction and limitations
    Rear View Monitor malfunction When the Rear View Monitor system encounters an internal electronic fault or signal interruption, the camera output image on your dashboard display may temporarily ...

    Highway Lane Change Assist: (if equipped)
    Display and control The state-of-the-art Highway Lane Change Assist system integrated into your Kia Sorento provides real-time operational feedback directly on the vehicle's instrument cluster ...

    Auto Defogging Actuator Description
    The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0489