Kia Sorento: Panorama Sunroof Motor Inspection
| 1. |
Close the panorama sunroof glass and blind completely (Full close
position).
|
| 2. |
Disconnect the negative (-) battery terminal.
|
| 3. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim")
|
| 4. |
Remove the panorama sunroof glass motor (A) after loosening the
screws and disconnecting the connector.
|
| 5. |
Check the wiring connector of the panorama sunroof glass motor
as below table.
|
| 6. |
Remove the blind motor (A) after loosening the screws and disconnecting
the connector.
|
| 7. |
Check the wiring connector of the blind motor as below table.
|
| 8. |
Connect the panorama sunroof glass and blind motor and each connectors.
|
| 9. |
Connect the negative (-) battery terminal.
|
| 10. |
Start the vehicle engine.
|
| 11. |
Check the motor's operation by pressing the panorama sunroof switch.
|
| 12. |
Pless the auto close switch after checking the motor's operation.
|
| 13. |
Install the panorama sunroof glass motor and blind motor. And
then perform the resetting procedure of the panorama sunroof.
|
Component Location
1. Automatic transaxle
2. Inhibitor switch
3. Transaxle Control Module (TCM)
4. Valve body cover
5. Solenoid valve connect
6. Oil temperature sensor
7. Valve body assemb ...
Inspection
1.
Remove the cowl top cover.
(Refer to the wiper)
2.
Disconnect the windshield deicer connector (A) from the wiper
motor linkage.
...
Transaxle Control Module (TCM) Installation
When replacing the TCM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the ...