Kia Sorento: Receiver-Drier Replacement - Air conditioning System - Heating,Ventilation And Air ConditioningKia Sorento: Receiver-Drier Replacement

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Receiver-Drier Replacement

1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench (A).


Tightening torque :
20 ~ 25 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.2 lb-ft)

3.
Remove the receiver-drier (A) from condenser using a long nose plier. Check for crumbled receiver-drier and clogged bottom cap filter.

4.
Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap.
5.
Insert a new receiver-drier into the receiver drier tank. The receiver-drier must be sealed in vacuum before it is exposed to air for use.
6.
Install a new bottom cap to the condenser.
  
    1. Recover the refrigerant with a recovery/recycling/charging station. 2. Disconnect the negative (-) battery terminal. 3. ...
    The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by oper...
    See also:

    Circuit Diagram
    ...

    Opening the fuel filler lid
    The fuel filler lid must be opened from inside the vehicle by pressing the fuel filler lid opener button on the driver ...

    General
    1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0517