Kia Sorento: Parking Brake Lever Assembly Removal - Parking Brake System - Brake SystemKia Sorento: Parking Brake Lever Assembly Removal

Kia Sorento (XM, 2011-2015) Service Manual / Brake System / Parking Brake System / Parking Brake Lever Assembly Removal

  
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
1.
Remove the floor console assembly.
(Refer to Body - "Floor console")
2.
Disconnect the connector (A) of parking brake switch.

3.
Loosen the adjusting nut (A) and the parking brake cables (B).

  
Parking brake lever in the car must be in fully loosened position.
4.
Remove the parking brake lever assembly (A) after removing the bolts.

Parking Brake Assembly Installation
Parking Brake Shoe 1. Install the shoe hold down pin (A) and spring (B) by pressing and rotating the spring. 2. Install the operat...
Parking Brake Lever Assembly Installation
1. Install the parking brake lever assembly (A). Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft) ...
See also:

Starting the engine
WARNING Never depress or hold down the accelerator pedal while starting your Kia Sorento. Uncontrolled engine revving can cause the vehicle to lunge forward ...

Forward/Reverse Parking Distance Warning malfunction and precautions
Forward/Reverse Parking Distance Warning malfunction ...

Fuel Filter Removal
1. Remove the fuel pump. (Refer to Fuel Delivery System - ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0609