Kia Sorento: Rear Coil Spring Removal - Rear Suspension System - Suspension SystemKia Sorento: Rear Coil Spring Removal

Kia Sorento (XM, 2011-2015) Service Manual / Suspension System / Rear Suspension System / Rear Coil Spring Removal

1.
Remove the rear wheel and tire (A) from rear hub .

Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

  
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

2.
Support the rear lower arm (A) with a jack as shown in the illustration.
  
Certainly install Jack as being danger because of the tension.

3.
Remove the spring (A), the upper pad (B) and the lower pad (C).

Tightening torque :
137.3 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)

4.
Installation is the reverse of removal.
5.
Check the wheel Alignment.
(Refer to Tires/Wheels - "Alignment")
Rear Lower Arm Inspection
1. Check the bushing for wear and deterioration. 2. Check the rear lower arm for deformation....
Rear Coil Spring Inspection
1. Check the spring for distortion, aging or damage. 2. Check the spring upper pad and lower pad for aging or damage....
See also:

Filler-Neck Assembly Removal
1. Lift the vehicle. 2. Disconnect the fuel filler hose (A). 3. Disconnect the ventilation tube quick-connector ...

Rear Corner Radar Installation
Installation Rear Corner Radar 1. Install in the reverse order of removal. ...

Blower Resistor Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0555