Kia Sorento: Blower Resistor Inspection - Blower - Heating,Ventilation And Air ConditioningKia Sorento: Blower Resistor Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Resistor Inspection

1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)

Blower Motor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the passenger side crash pad under cover (A). 3. D...
Blower Resistor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the passenger side crash pad under cover (A). 3. D...
See also:

Installation
   ...

Opening the fuel filler door
Turn the engine OFF completely and ensure the vehicle is safely parked before attempting to refuel. Make sure the driver's door is unlocked, as the fuel door locking mechanism operates in s ...

Temperature Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0533