Kia Sorento: Rear Stabilizer Bar Removal
| 1. |
Remove the rear wheel and tire (A) from rear hub .
|
| 2. |
In the case of 4WD vehicle, remove the rear differential assembly.
(Refer to Driveshaft and axle - "Rear Differential Carrier")
|
| 3. |
Loosen the nut (A-1ea) and then remove the rear stabilizer link
(B).
[2WD]
[4WD]
|
| 4. |
Loosen the bolt and then remove the rear stabilizer bar (A) with
the sub frame.
[2WD]
[4WD]
|
| 5. |
Installation is the reverse of removal.
|
Valve Body Installation
1.
Install in the reverse order of removal.
...
Photo Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
With a flat-head screwdriver, remove the photo sensor (A) from
the center of the defros ...
Height Adjust Removal and Installation
Removal
1.
Remove the center pillar upper trim.
(Refer to Body - "Center Pillar Trim")
...