Kia Sorento: Removal - ETC (Electronic Throttle Control) System - Engine Control System - Engine Control / Fuel SystemKia Sorento: Removal

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the resonator and the air intake hose.
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Disconnect the ETC module connector (A).
4.
Disconnect the coolant hoses (B).
5.
Remove the installation bolts (C), and then remove the ETC module from the engine.

Inspection
Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1...
Installation
  ...
See also:

Engine Cover Removal and Installation
1. Remove the engine cover (A). 2. Install in the reverse order of removal. ...

Rear Differential Carrier Repair procedures
Removal 1. Disconnect the (-) battery terminal. 2. Remove the rear driveshaft. ...

Receiver-Drier Replacement
1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench (A). Tight ...

Copyright © xm.ksmanual.com 2014-2026 - 0.052