Kia Sorento: Replacement - Injector - Engine Control System - Engine Control / Fuel SystemKia Sorento: Replacement

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / Injector / Replacement

The injector combustion seal should be replaced new one to prevent leakage after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.

  
Grip the sealing ring carefully, pull it to form a small loop and then cut it.
Be careful not to damage the surface of the valve sleeve with the wire cutter.
2.
Before the assembly of the sealing ring the groove must be cleaned using a clean cloth.
Any coking of the injector sealing surface must be carefully removed with a brass-wire brush.

  
The surfaces of the new sealing ring must be clean and free of grease.
3.
Place the seal installing guide (B) (SST No.: 09353-2B000) on the tip of the injector not to damage the injector tip (A).
Push the sealing ring (C) with thumb and index finger over the conical assembly tool until it snaps into the groove.
The complete assembly must not take longer than 2 to 3 seconds.

4.
To size the sealing ring the injector is first introduced into the sizing tool (A) (SST No.: 09353-2B000) and then pressed and at the same time rotated 180
    Installation
    1. Combustion seal 2. Rubber washer 3. Support disc 4. O-ring ...
    Purge Control Solenoid Valve (PCSV)
    Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM grounds ...
    See also:

    Knock Sensor (KS) Specifications. Knock Sensor (KS) Components and Components Location. Knock Sensor (KS) Description and Operation
    Knock Sensor (KS) Specifications. Knock Sensor (KS) Components and Components Location Knock Sensor (KS) Specifications Specification Item Speci ...

    Multimedia Keyboard Repair Procedures
    Removal 1. Remove the passenger's side crash pad garnish. (Refer to Body - "Crash Pad Garnish") ...

    Head Lamps Removal
       Head lamps become very hot during use; do not touch them or any attaching hardware immediately after they have been turn ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0459