Kia Sorento: Side Airbag (SAB) Module Installation
|
Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
| •
|
Do not open the lid of the side airbag cover.
|
| •
|
Make sure that the airbag assembly cover is installed
properly. Improper installation may prevent the proper deployment.
|
|
|
1. |
Remove the ignition key from the vehicle.
|
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
|
3. |
Install the new seat back assembly. (Refer to the Body group-
Seat)
|
|
4. |
Install the front seat assembly. (Refer to the Body group- Seat)
|
|
5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfering with other parts.
|
|
6. |
Reconnect the battery negative cable.
|
|
7. |
After installing the side airbag (SAB), confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
1.
...
Curtain airbags are installed inside the headliner (LH and RH) and protect
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of curtain airbag by using...
See also:
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
➀ BSD ...
Injector
The GDI injector is similar to a standard injector, but sprays fuel at
a much higher pressure directly into the combustion chamber and has a swirl
disc to get the fuel swirling as it exits th ...
Warning And Caution Labels
1. Fan caution
2. Radiator cap caution
3. Battery caution
Battery Caution Label Description
Warning / Caution Label (Cont'd)
A.
Keep lighted cigarett ...