Kia Sorento: Side Impact Sensor (SIS) Installation
| •
|
Do not turn the ignition switch ON and do not connect
the battery cable while replacing the side impact sensor.
|
|
|
1. |
Install the new front side impact sensor with the bolt then connect
the SRS harness connector to the front side impact sensor.
Tightening torque
: 5 ~ 7 Nm (0.5 ~ 0.7 kgf.m, 3.7 ~ 5.2 lb.ft)
|
|
|
2. |
Install the front door trim. (Refer to the Body group- Front door)
|
|
3. |
Reconnect the battery negative cable.
|
|
4. |
After installing the front side impact sensor, confirm proper
system operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
• |
Failure to torque the bolts to specification can
cause the sensor (FSIS, P-SIS) to break or the nut setter
insert to spin.
|
|
• |
Problems may occur with the inpact sensor pertormance
if the nut insert is spinning.
|
|
• |
The door seal must not be damaged and must remain
sealed. The SRSCM monitors the pressure sensor in the
door module to indicate an impact.
|
|
|
Rear Side Impact Sensor
| •
|
Do not turn the ignition switch ON and do not connect
the battery cable while replacing the side impact sensor.
|
|
|
1. |
Install the new side impact sensor with the bolt then connect
the SRS harness connector to the side impact sensor.
Tightening torque
: 6.8 ~ 9.2 Nm (0.7 ~ 0.9 kgf.m, 5.0 ~ 6.8 lb.ft)
|
|
|
2. |
Install the luggage side trim. (Refer to the Body group - Interior
trim)
|
|
3. |
Install the rear seat . (Refer to the Body group- Seat)
|
|
4. |
Reconnect the battery negative cable.
|
|
5. |
After installing the Side Impact Sensor, confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
Front Side Impact Sensor
•
Removal of the airbag must be performed according to the
...
The SRSCM shall monitor the status of the driver and front passenger seat
belt buckle. The SRSCM provides one pin each for the driver and front passenger
seat belt buckle status input. The seat ...
See also:
Smart key unit Inspection
Smart Key Unit
-
Refer to BE group - inspection / self diagnosis with scan tool.
Smart Key Switch
-
Refer to BE group - inspection / self diag ...
Fuel Pump Motor Installation
1.
Install in the reverse order of removal.
...
Removal
•
DON’T remove the camshaft position sensor while the engine
is running or right aft ...
Side Impact Sensor (SIS) Removal
Seat Belt Buckle Switch (BS) Description
