Kia Sorento: Steering Angle Sensor - ESC(Electronic Stability Control) System - Brake SystemKia Sorento: Steering Angle Sensor

Kia Sorento (XM, 2011-2015) Service Manual / Brake System / ESC(Electronic Stability Control) System / Steering Angle Sensor

The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning direction and speed of the steering wheel.
The HECU uses the signals from the SAS when performing ESC-related calculations.
Components (Steering Angle Sensor, Torque Sensor, Failsafe relay, etc.) of the EPS system are located inside the steering column & EPS unit assembly and the steering column. EPS unit assembly must not be disassemble to be inspected. They must be replaced. (Refer to “ST (Steering system) Gr.”)
ESC OFF Switch Inspection
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer the Body - "Crash ...
Body (Interior and Exterior)
...
See also:

Pretensioner seat belt
Your Kia Sorento is equipped with an advanced pretensioner sea ...

Piston and Connecting Rod Disassembly
   • Use fender covers to avoid damaging painted surfaces. • ...

Components
1. Piston ring 2. Snap ring 3. Piston 4. Connecting rod 5. Connecting rod upper bearing 6. Piston pin 7. Connecting rod lower bearing 8. Connecting rod bearing cap ...

Copyright © xm.ksmanual.com 2014-2026