Kia Sorento: Temperature Control Actuator Inspection - Heater - Heating,Ventilation And Air ConditioningKia Sorento: Temperature Control Actuator Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Heater / Temperature Control Actuator Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the temperature control actuator operates to the warm position when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the temperature control actuator operates to the cool position when connected in reverse.
[Driver's side]

1. -
2. -
3. Cool position
4. Warm position
5. Sensor (+ 5V)
6. Feedback signal
7. Sensor ground


[Passenger's side]

1. -
2. -
3. Warm position
4. Cool position
5. Sensor ground
6. Feedback signal
7. Sensor (+ 5V)

4.
Connect the temperature control actuator connector.
5.
Turn the ignition switch ON.
6.
Check the voltage between the terminals.
A.
Driver's side: 6 and 7
B.
Passenger's side: 5 and 6
Specification
Door Position
Voltage (V)
Error Detecting
Max. cooling
0.3
    The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure...
    [Driver's side] 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the driver's side cras...
    See also:

    Canister Removal
    1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. D ...

    Rear Coil Spring Repair procedures
    Removal 1. Disconnect the (-) battery terminal. 2. Remove the rear wheel and t ...

    AC Inverter Unit Repair Procedures
    Removal 1. Remove the luggage side trim. (Refer to Body - "Luggage Side Trim") ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0555