Kia Sorento: Temperature Control Actuator Replacement - Heater - Heating,Ventilation And Air ConditioningKia Sorento: Temperature Control Actuator Replacement

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Heater / Temperature Control Actuator Replacement

[Driver's side]
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the driver's side crash pad side cover.

3.
After loosening the mounting screws, remove the crash pad lower panel (A).
4.
Push the lock pin (B), disconnect the diagnosis connector (C).

5.
After loosening the mounting bolts, then remove the reinforce panel (A).

6.
Remove the driver's side shower duct after loosening the screw.
7.
Disconnect the temperature control actuator connector (A).
8.
Remove the temperature control actuator (B) after loosening the mounting screws.

9.
Install in the reverse order of removal.
[Passenger's side]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Crash Pad")
3.
Using a screwdriver or remover, remove the crash pad side cover (A).

4.
Disconnect the stopper (B) from the glove box (A).

5.
Disconnect the air damper (A) from the glove box (B).

6.
Disconnect the pins (A) and then remove the glove box (B).

7.
After loosening the mounting screws, then remove the crash pad side garnish [RH] (A).

8.
After loosening the mounting screws, then remove the crash pad under cover (A).

9.
After loosening the mounting screws, then remove the glove box housing (A).

10.
Disconnect the glove box lamp connector (A).

11.
Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.

12.
Install in the reverse order of removal.
Temperature Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature ...
Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing th...
See also:

Speakers Inspection
1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the s ...

Seat Heater Installation
1. Install the driver / assist seat heater. (Refer to Body - "Front seat") 2. Install the rear seat LH heater and RH heater. ...

Engine overheat
If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine will probably be too hot. If this happens, you should: 1.Pull off the r ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0489