Kia Sorento: Thermostat Removal and Installation - Cooling System - Engine Mechanical SystemKia Sorento: Thermostat Removal and Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Cooling System / Thermostat Removal and Installation

  
Removal of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat.
1.
Drain engine coolant so its level is below thermostat.
2.
Remove the radiator lower hose (A).

3.
Remove water inlet fitting (A), gasket (B) and thermostat (C).

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.
Install in the reverse order of removal.
  
Install the thermostat with the jiggle valve upward.
5.
Fill the engine coolant.
6.
Start the engine and check for leaks.
7.
Recheck the coolant level.
Water Temperature Control Assembly Removal
1. Disconnect the battery negative terminal. 2. Loosen the drain plug and drain the engine coolant. 3. Remove the radiato...
Thermostat Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. Valve opening t...
See also:

Parking Brake Pedal Assembly Adjustment
Parking Brake Pedal Stroke Adjustment 1. Operate the parking brake pedal through a full stroke over 3 times for setting the parking cables. 2. ...

Front Fog Lamps Installation
1. Install the front fog lamp bulb. 2. Connect the fog lamp connector. 3. Install the front tire wheel guard. ...

Forward Collision-Avoidance Assist malfunction
(A) Check Driver Assistance system ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0523