Kia Sorento: Water Temperature Control Assembly Removal - Cooling System - Engine Mechanical SystemKia Sorento: Water Temperature Control Assembly Removal

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Removal

1.
Disconnect the battery negative terminal.
2.
Loosen the drain plug and drain the engine coolant.
3.
Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator")
4.
Disconnect the connectors and then remove the wiring protector (A).

5.
Disconnect the E.T.C cooler hose (A) and the remove the water temperature control assembly(A).

6.
Install in the reverse order of removal.
Water Temperature Control Assembly Components
1. O-ring 2. Water temperature control assembly 3. Water inlet fitting 4. Engine coolant temperature sensor 5. Thermostat 6. Thermostat gasket 7. Oil cooler coolant hose...
Thermostat Removal and Installation
   Removal of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine ...
See also:

Master Cylinder Removal
1. Turm ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly. G 2.4 GDI (Refer to ...

Condenser Removal and Installation
Removal ...

Component Location
1. Start relay #2 (W/O immo./smart key) / ACC relay (With smart key) 2. Start relay #1 3. Windshield deicer relay 4. Power outlet relay 5. Wiper relay (low) 6. Burgla ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0451