Kia Sorento: Transaxle Oil Temperature Sensor Inspection - Automatic Transaxle Control System - Automatic Transaxle SystemKia Sorento: Transaxle Oil Temperature Sensor Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Inspection

1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
3.
Disconnect the solenoid valve connector (A).

4.
Measure resistance between sensor signal terminal and sensor ground terminal.
5.
Check that the resistance is within the specification.
Transaxle Oil Temperature Sensor Circuit Diagram
...
Transaxle Oil Temperature Sensor Removal
1. Remove the battery and the battery tray. (Refer to Engine Electrical System - "Battery") 2. Remove the under cover. (Refer to...
See also:

Rail Pressure Sensor (RPS)
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor ...

Installation
   ...

Rear Stabilizer Bar Repair procedures
Removal [2WD] 1. Disconnect the (-) battery terminal. 2. Remove the and nuts ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0534