Kia Sorento: Windshield Wiper-Washer Switch Inspection - Windshield Wiper/Washer - Body Electrical SystemKia Sorento: Windshield Wiper-Washer Switch Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch Inspection

Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch.

Wiper Switch

Washer Switch

Rear Wiper Switch

Rear Washer Switch

Head Lamp Washer Switch
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")

3.
Remove the side garnish (A) after loosening the screws.

4.
Remove the head lamp washer switch (A).

5.
Make sure that the continuity exists between the terminals as below. If it is not normal condition, replace the head lamp washer switch

Windshield Wiper-Washer Switch Installation
1. Install the windshield wiper switch. 2. Connect the wiper switch connector. 3. Install the steering column upper and lo...
Front Wiper Motor Component Location
1. Cap 2. Nut 3. Wiper arm & blade 4. Retainer 5. Cowl top cover 6. Bolt 7. Wiper motor & linkage assembly 8. Wiper motor connector...
See also:

Spark Plug Cleaning
Cleaning The combustion temporarily becomes unstable, due to the aged fuel and the carbon deposits accumulated on the spark plug(s) after long-term storage. ...

Engine Control Module (ECM) Circuit Diagram
...

Positive Crankcase Ventilation (PCV) Valve Installation
1. Install in the reverse order of removal. PCV Valve installation: 1.9 ~ 2.8 N.m (0.19 ~ 0.29 kgf.m, 1.4 ~ 2.1 lb-ft) ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0464