Kia Sorento: 4WD ECU Removal
Kia Sorento (XM, 2011-2015) Service Manual / 4 Wheel Drive (4WD) System / 4WD Control System / 4WD ECU Removal
| 1. |
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing
with the GDS tool.
(Refer to 4WD Control System - "Repair procedures")
|
| 2. |
Disconnect the battery negative cable from the battery
|
| 3. |
Disconnect the 4WD ECU connector (A).
|
| 4. |
Loosen the nuts (A) and then remove the 4WD ECU.
|
4WD ECU Circuit Diagram
4WD ECU Installation
1.
Install in the reverse order of removal.
2.
Prior to installing a new ECU, upload the original ECU’s clutch
learing to the replacement ECU using ...
See also:
Components Location
Supplemental Restraint System Control
Module (SRSCM)
Driver Airbag (DAB) / Passenger Airbag
(PAB)
Side Airbag (SAB)
Curtain Airbag (CA ...
Fluid Replacement
The ATF of the 6 speed automatic transaxle does not need to be
replaced.If the vehicle is used in severe conditions or b ...
Balance Shaft & Oil Pump Installation
BSM(Balance Shaft Module) Chain System
1.
The key of crankshaft should be aligned with the mating face of main
bearing cap. As a result of this, the piston of No.1 cylinde ...
Manuals list
- Kia Sorento MQ4 2021-2026 Owners Manual
- Kia Sorento XM 2011-2015 Owners Manual
- Kia Sorento XM 2011-2015 Service Manual
Copyright © xm.ksmanual.com 2014-2026