Kia Sorento: ATF Warmer Removal - Hydraulic System - Automatic Transaxle SystemKia Sorento: ATF Warmer Removal

Kia Sorento (XM, 2011-2015) Service Manual / Automatic Transaxle System / Hydraulic System / ATF Warmer Removal

1.
Drain the coolant.
(Refer to Engine Mechanical System - "Coolant")
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
3.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
4.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
5.
Disconnect the coolant hose (B) after removing the coolant hose clamp (A).

6.
Disconnect the hose (B) after removing the automatic transaxle fluid cooler hose clamp (A).

  
When hose & pipe assembly
Align marking of pipe (B), marking of hose (A), and matching color each other.

7.
Remove the ATF Warmer (A).

Tightening torque :
(A) 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

ATF Warmer Component
1. ATF Warmar 2. Bypass valve 3. ATF hose & pipe 4. Coolant hose & pipe...
ATF Warmer Installation
1. Install in the reverse order of removal.   ...
See also:

Side Body A
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Input Speed Sensor Description
Input speed sensor (A) is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the Transaxle Control Module(TCM). The sensor pr ...

Fluid Service Adjustment Procedure
Oil level Check    A check of ATF level is not normally required during scheduled services. If an oil leak is ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0687